Subject: Good news and bad news
From: ACRE
Date: 3/30/2003, 10:07 AM


That's pretty good Chrissi. The excess material provides a opportunity for people to express
their creativity :)

Here is a picture of a box of water pump castings. I'll try to get
at least one machined before I leave.

Save one for us, we need it! will pay you at the show.
...Chrissi


OK

BTW I talked to the foundry yesterday about a process called ball burnishing.
It is a low cost finish applied to the outside of a sand casting that markedly
improves the surface finish and the appearance. Like $15 or $20 bucks
per casting. Not expensive as polishing but polishing can be applied
after the ball burnishing.

Paul Lamar


That would be great, there is only so much I can do with a dremel and a mill. The internal stuff
is a pain as well, I just have not found the right tools for the job yet.
...Chrissi

More bad news. I made a major screw up when I scaled the pattern for shrinkage
and all 17 castings are junk. This will set the water pump back
a month as I have no time between now and SnF to get another pattern
in the foundry. I did use one of them to check the machining techniques
and it is doable but time consuming. I'll have a picture of that tomorrow.

Paul Lamar

This unit doesn't fit the cartridge but I used it to test machining
techniques. There is enough meat on the outlet side to drill & tap it for
a large AN hose assembly if you wish.  The other picture is
what the inside looks like after it is machined. The hold down
bolts are not drilled as this unit is slightly over sized and
they would come out in the wrong place.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.