William wrote:

we are considering bringing ours but it is all cut up and partially

polished... not representative

of the product received.. removed 24 oz so far.
...Chrissi

Chrissi,
Can you post a picture of your efforts and where the most material came
from?
Bill Schertz

One thing Bill, Chrissi has a 3rd gen so there will be differences.

Paul Lamar

Here is front and back. Except for trimming the edges and hogging off material, the rest was done
with an air die grinder (thumb is recovering nicely).
One small slip inside the port edge may require welding and regrinding for a good seal on gasket.

Nice work Chrissi. Can I send you mine and have you do the same thing?
I'll have to modify the pattern and make them look like that.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.