If you want to do a little mild hop up on your
water pump you can remove a bit of material around
the center of the impeller like this Cosmo pump impeller.
Here is the stock 13B impeller compared to the Cosmo
impeller. I suspect the three rotor uses the Cosmo
pump.
One way is set up the cartridge so it can be driven by
a drill press or lathe and then used a hand held grinder
to remove the material around the hub of the impeller
while it is spinning.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2002 All world wide rights reserved.