Subject: Good news and bad news
From: ACRE
Date: 3/31/2003, 5:56 PM


This unit doesn't fit the cartridge but I used it to test machining
techniques. There is enough meat on the outlet side to drill & tap it for
a large AN hose assembly if you wish.  The other picture is
what the inside looks like after it is machined. The hold down
bolts are not drilled as this unit is slightly over sized and
they would come out in the wrong place.

Paul Lamar


Paul,
Can you briefly explain the calculations you are using to allow for
shrinkage of aluminium, through the foundry process.
George (down under)

1/4 inch per foot.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.