CliveClapham wrote:
From Clive Clapham
clive@clapham55.fsnet.co.uk
Lycoming style engine mount accessory cover
I am investigating casting an accessory cover to replace the stock Mazda cover. So far I have
roughed out a mock up in foam. With the following objectives:
* Replacement of stock Mazda cover & water pump housing in one piece with integral filler cap.
* To be able to bolt straight onto stock Lycoming ( conical ) engine mount. Dynafocal possible
would depend on demand.
* Relocate water pump & alternator to same unit
* No distributor drive height problem by deleting distributor (crank Sensor)
* Weight saving about 15lbs
* No new aircraft engine mount to fabricate weight saving and cost saving for many existing
aircraft from 0235 to 0360.
* Same thrust line as Lycoming
As this is still in the design and fabrication stage.
I would be interested to have input from anyone who is potentially interest to asses demand and my
design goals are on the right track.
PLEASE E-MAIL ME DIRECT
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2002 All world wide rights reserved.