Subject: Tracy goes 209 MPH in Sun 100 cross countery air race
From: ACRE
Date: 4/11/2003, 9:40 AM


Paul wrote:

Tracy beat all the Lycoming 320 cubic inch powered airplanes
and half the Lycoming 360 cubic inch powered airplanes.
He also won $500 for his 26 minutes of work.

Congrats, Tracy!  Now we need to work on beating the remaining
half.

Russell Kent


        AND getting ALL of the cooling bugs taken care of, Virg


Virgil N. Salisbury AMSOIL
WWW.LUBEDEALER.COM/SALISBURY

Not really. He cheated with a water spray. OK for racing as it only
took 26 minutes to go 100 miles. The duct tape holds the water
spray pipe in place.

Paul Lamar

True, there was a simplified version of my "Oshkosh ground cooling system"
installed.  Took about 15 minutes to put in.  But if anyone thinks serious
cooling problems can be solved this easily, think again.

In years past the temperature at Sun 'n Fun has been in the 90's so I stuck
on the water plumbing as a last ditch measure.  Not really a spray-bar, just
a 3/32" ID  squirt nozzle that did not distribute the water, very
inefficient way to do it.

As it turned out, the weather was mild on race morning and no aux cooling
was needed.  Oil temp stabilized at 205 and water temp at 193, completely
acceptable temps for racing.  On the last leg of the race I turned on the
water to see the effect.  Oil temp dropped about 10 - 12 degrees but I
didn't get around to measuring the water temp  drop during the "heat of
battle".   I was too busy watching the two planes I passed and staying clear
of the third that I caught up to at the finish line.  I was afraid that I
would be disqualified for busting the 500 foot minimum at the finish when I
had to duck below him.

Other factors in the race included my "race tape" over the large gaps
between cowl & fuselage which began pealing off immediately after takeoff,
the draggy external muffler which I left in place (everyone said mine was
the quietest plane in the race) and the economy cruise fuel mixture that I
ran.  My plan was to run at 16 GPH for the race but I increased it to 17
when the air speed started dropping due to increased drag of the pealing
tape.  (amazing what a difference it made!)  At best power mixture my engine
is burning 20 GPH at WOT at sea level.  The veteran racers flew at tree top
altitude while I flew between 1000 - 1800 feet for most of the race.

I've always said that top speed numbers on airplanes aren't good for
anything other than bragging rights around the hangar (still do!) but I must
admit that it was a blast flying in the race  and I'll do it again next
year.

Tracy Crook
tcrook@rotaryaviation.com
www.rotaryaviation.com

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.