Vance W Jaqua wrote:
Paul - I think you were there when Butch came by and described an
engine he saw on display. It had what was touted as an electric
blower to flat rate at 10K. ( See Pix), It looks like a model
airplane electric ducted fan assembly, and was rated 20 amp
at 12 volts (about 1/3 hp). Butch felt that the engine looked
well made (and with good reason - it is a 3.5l Honda V6)
My best estimate says about 0.1 psi boost at that power,
not hardly flat rate by any measure - "let the dreams begin"
Vance
Maybe what it needs is six of these :)
Paul Lamar
Very pretty installation. Even if it is crap, it is packaged well. Looks
from this angle like they have the driving pulley cantilevered off the
crankshaft. One of Paul's favourite design features :) They stole Pauls idea
of a tubing PRSU front bearing support.
The weird thing is that Boeing is marketing their next airliner, the 7E7,
without engine compressor bleed air driven systems. They want to replace the
bleed air driven Aircon system with an electrically driven one. I would
think that, even with ram recovery providing most of the pressure and
some of the temperature rise, you will still need to feed a huge amount of
electrical energy into powerful motors to get the pressure, temperature and
mass flow rate for a worst case single Pack inop at high altitude condition.
At least they will have high voltage three phase power to play with. The 777
has 120 KVA main generators on each engine, and has problems with the power
feeder cables welding at the lugs. The 7E7 will need a few extra. of these
generators.
Mark
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2002 All world wide rights reserved.