Subject: Aluminum end housings
From: ACRE
Date: 4/12/2003, 8:00 AM


It would seem the obvious solution to incorporate the dynafocal mounts into the front end
housing
and be done with it. Then the 13B would be well on it's way to being "normal" in more aircraft
applications.
...Chrissi

We choose the center housing as it is the simplest to make and we can
porous chrome one steel side and harden the other steel side as a back to back test.

Using a separate water pump simplifies the front end housing.

Actually it was the advent of the new pump and allowing simplification of the water inlet/outlet
ports (make round) as well as removing the crank angle sensor and oil injection pump...whats left?
... add an oil filler tube to the new cover is about it. All this would have been a real trick to
CNC out of a slab but a casting is a whole new animal. A lot of bang for the buck.
...Chrissi

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.