It would seem the obvious solution to incorporate the dynafocal mounts into the front end
housing
and be done with it. Then the 13B would be well on it's way to being "normal" in more
aircraft
applications.
...Chrissi
We choose the center housing as it is the simplest to make and we can
porous chrome one steel side and harden the other steel side as a back to back test.
Using a separate water pump simplifies the front end housing.
Actually it was the advent of the new pump and allowing simplification of the water
inlet/outlet
ports (make round) as well as removing the crank angle sensor and oil injection pump...whats
left?
... add an oil filler tube to the new cover is about it. All this would have been a real trick
to
CNC out of a slab but a casting is a whole new animal. A lot of bang for the buck.
...Chrissi
BTW, a friend just aquired a CNC gantry mill/router/plasma cutter that can handle 4'x8'x6"
material... need any lost foam patterns? Might be good for complex internal coolant passages etc.
...Chrissi
Is that really only 6" in the Z direction Chrissi? Does he have a program
that can accept IGES files and convert them to G codes?
We still need a pattern for gear box castings usings Tracy's 2.85:1 internals.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2002 All world wide rights reserved.