I think we have a new winner in the intake manifold contest.
The artist that did this one appears to want to remain
anonymous as he sent the pictures and labeled them private :)

You can always claim your credit  Mr. Anon at any time.

Paul Lamar

William wrote:

 Very nicely done. I have a question for the "artist". It looks like this is

for a 88-89 version, and the center hole (between the smaller tubes) is very
close to the openings on the gasket side.  Did you make the 'web' that is
remaining on the flange the same thickness as the web on the other holes, or
is it thicker? Can't tell from the photos.  I have been concerned with
breaking through the holes if I remove too much material in that spot.

How much does the manifold weigh in the photographed condition?

Bill schertz, still grinding

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.