Subject: aluminum end housings
From: ACRE
Date: 4/12/2003, 7:54 AM

Walter Williams wrote:

hi Paul,  please do the rear housing first.  it has the most weight savings and us single rotor
guys can get moving. i will take ten right now and put up some development money.  if you are
pretty sure this co. can get the job done.  thanks walt


This is a large financial risk for the pattern (on the order of $15,000) and we must minimize 
the risk to discover show stoppers if any.  I cannot do the pattern in the STL machine
as it is too large. Therefore it is much easier to do a center housings first.

BTW as a matter of back ground info my foundry showed me a nice V8 intake
manifold pattern that cost $17,000. 

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.