Subject: Aluminum end housings
From: ACRE
Date: 4/13/2003, 3:30 PM


Carbon chrome molly steel. 4130 or 4340. Heat treated.

Paul Lamar


We have cut about 6 engines into iddy biddy pieces to see how it is
made, how it
works, and how it can be hot rodded.
In doing all this we decided to abandon the idea of mixing two different
metals
for several reasons.
We now know how to mill two aluminum plates that get bolted together to
form
each housing.
No wear plate needed, and no problems of seperation or flaking.
Anyone with a "cc" mill and aluminum drops can make their own end
housings.
It's a simple process.
Royce

Royce,
How do you propose sealing the "two aluminium panels", from my observations
(cut housings) there is little room for simple O-ring seals. The bolts also
need to be sealed and there is the inlet areas which are difficult. I assume
the water jacket area can be reduced to address those problems - is this
what you propose.
Also what do you propose for a wear surface.

George, we will use simple gaskets. Or "one" to be exact. We will still use the
TES o' rings between the rotor housings and the end housings.  The end housing
plates are sealed with Fel-Pro "KARROPAK".
There are only water passages to be sealed, the combustion chambers are still
sealed with the factory o' rings.  The bolts will still use seals like the factory
does. The water jacket remains the same volume as the factory.
The plates are held together with the tension bolts on the outer perimeter, and
the rear bearing support, and the front stationary gear bolts secure them at the
center. There is also four other bolts scattered between these rings of bolts.
Don't see anyway the housing plates can move, or seperate from heating and
cooling.
The wear surfaces are "Hard Anodized" to rockwell 55 to 60, the same as the
factory end housings, and then lapped with optical grade lapping compound to the
mirror finish neccessary.
Don't understand what you mean about the inlet areas being difficult?

Royce

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.