Subject: Aluminum end housings
From: ACRE
Date: 4/13/2003, 11:08 PM


Lets cut to the chase here Royce. I think what people want to know is:
Are you using the bare aluminum as the wear surface?

Paul Lamar

Sure, only with the surface hardened to RC55.
Royce

7075T6 is the hardest aluminum around and it is Brinell
150. RC 55 is off the Brinell scale with the standard 10 mm ball and
is Brinell 546 with the Hultgren ball whatever that is.

http://www.cknife.com/compare.htm

Paul Lamar

Not seeing your point here Paul.
Royce

The max hardness one can get with aluminum is Brinell 150
which is off the bottom of the Rockwell C chart.
Brinell 200 is Rockwell 15.

My guess is less than Rockwell C 10. That is well shy
of what is required for a wear surface. An acceptable
wear surface hardness would be Rockwell C60.
http://www.anvilfire.com/FAQs/hardness.htm

Main reason why bare aluminum cannot be used as a wear surface.


Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.