I have several hundred hrs on the 2mm three piece seals but
switched to the 3mm two piece seals and would highly suggest them.
As for detonation yes it does increase the chance, to eliminate
detonation I have a relay that kills the trailing ignition as it is
near impossible to detonate with the trailing ignition off, also I use
MSD ignition and I use their 8980 timing computer to retard the
leading ignition.
With this timing computer I can also retard the timing in flight on
long hard climb outs with a dial that runs from 0 to 12 degrees.
Ken Welter
"Brian D. Cain" wrote:
With all due respect Ken, I'm not so certain I agree with all of this. I've
had massive amounts of "field" (high-load racing, etc.) experience with this
area of the rotary engine and I've got some opinions based on that
experience.
First off, I'm not certain that removing trailing ignition will completely
stave off
any chance of auto-igniting the mixture using only leading plugs. If spark
timing is too far advanced for the load being put on the engine with the
leadings, they will pre-ignite the mixture. Even with trailing plugs,
configured
with a "thin" trail-split timing (having the trailing plugs fire very close
to
the leadings instead of 15 degrees apart per the stock Mazda computer
On the issue of 2mm vs. 3mm apex sealing, for any of you guys that have
cruised the various Rx-7 forums and lists out there, this has been a raging
debate
by the "experts" for quite awhile. I ran a 3mm apex seal setup in my last
race engine and the engine held up for quite some time. The last engine
we've
setup, however, still uses 2mm. From what I gather about it all, the 3mm
apex seal is a choice if you're looking for 'insurance' where, in the event
of serious
engine knock (honestly, with what you guys are running being mostly
normally-
aspirated powerplants, you shouldn't have an issue with this whatsoever),
the seal
will be considerably more resilient to cracking and shattering at the ends.
But,
on the flip-side of the coin, I gather that a 3mm apex seal will wear the
rotor housing
out much more quickly and may not be as efficacious for long-term operation.
Now, with nitrous oxide injection being introduced into the picture, I don't
think
that will have any detrimental affects whatsoever. Depending on the drastic
temperature drop and the amount of mass that's added to the combustion
chamber,
leading spark timing will have to be retarded several degrees. But,
otherwise, I
think it oughta be just fine to run a 2mm apex seal setup with that.
There's plenty
of engines out there that run higher turbocharged boost pressures, with
hotter
intake temperatures (ones that may want to induce serious engine knock), on
2mm
apex seals that run just fine without any hint of problems.
That's my $0.02 on it. Hope it helps,
Brian Cain
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.