My guess is less than Rockwell C 10. That is well shy
of what is required for a wear surface. An acceptable
wear surface hardness would be Rockwell C60.
http://www.anvilfire.com/FAQs/hardness.htm
Main reason why bare aluminum cannot be used as a wear surface.
Anodizing flakes and doesn't work well on 7075 anyway.
Paul, there is one instance where aluminum is used as a running surface. The aluminum used in the
Vega engine block. Don't laugh because it's bad rep in the Vega was undeserved, they had a valve
guide problem everyone thought was the block. The process was picked up by Benz and Porsche both
making V-8's. The 928 used it. The material was a special alloy with a special hard alloy mixed
in. The machining was done down to honing and then a special etch was used to "peel back" the
softer material. To prevent the aluminum piston from spauling (welding) they iron plated them.
But you know that anyway. I doubt that the special alloy chevy used would hold up to the rotary
tip and side seals anyway. It made a harder than normal surface but it was better suited to round
bores. I am fairly sure Jim Hall had some of these blocks available in your era there. Mclaren
definitely did, but they weren't engines intended to leave the ground. Quite the opposite in fact!
Bill Jepson
As I recall that was a high silcon content (sand). I don't think we ever used them
but I could be wrong. The engines arrived from Chevy R&D in a crate and went back after
the race. Usually as a pile of junk at that point :)
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.