Yes like I said I have about five hundred hrs flying on the 2mm
seals but I just like the extra insurance of the 3mm but I also have
about five hundred hrs flying on 3mm seals and they seam to work fine
to with no excess wear.
As for the trailing ignition, this is not something I dreamed up on
my own as it was suggested to me by Skip Gorman and by Rob Golden and
I can tell you from experience that when I got detonation on a hard
climb out without NOS that the detonation would stop instantly when I
killed the trailing ignition and if I turned it back on it would
start detonating again, also I fire the leading and trailing at the
same time so it has noting to do with timing.
The theory that has been explained to me is that trailing plug is to
burn up all the gas at the tail edge of the combustion camber and
some fire may be getting around the apex seals to cause the
detonation and by not burning all that fuel mixture back there it is
leaving a safety cushion to stop the leakage but all that is theory
and all I can tell you is it works, done it did it been there.
Ken Welter
"Brian D. Cain" wrote:
That's my chief concern with 3mm apex seals, Ken -- Whether or not
they lead to an overall higher wear on the rotor housing. Since they are
thicker and heavier, I'd suspect they would (unless data to the contrary
can be given). The other thing about them I am curious of is whether or
not they seal for compression as good as 2mm seals -- there's a reason
why Mazda went from 3mm to 2mm; I'm just sure what it is (I suspect
low RPM, low-load emissions, perhaps). If you can shed some light on
this, then perhaps you can more than well prove your case that 3mm is
the much preferred choice. Until then, I'll throw my hands up in the air
and say, "I don't know". :)
Regards,
B
Low RPM low load for the 2 mm. No difference in sealing at our RPM levels.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.