Subject: Twin 13b's, one prop
From: ACRE
Date: 4/16/2003, 7:30 PM


phillip wrote:

It's pretty simple. I guess described as one ring and two pinion
gears.
I left out bearings and seals. I'm not an artist. :)

Thanks Paul

Phil


Sure something like that will work. The devil is in the details of
course.

Paul Lamar


Prop load om power boats is very similar to aircraft - ie speed
and rpm are roughly cubic functions. on single engine operation
both rpm and speed would drop to about 80 percent of top
since you will be overproped for the single ongine and it will
also be lugged down on the power curve limiting it's
max power output.  Many power boats are going to counter rotating
props - using each engine for each rotation (like the South American
canard installation) will let the remaining engine develop full HP -
Vance

Could I steer this thread towards the same concept, only in a coaxial
helicopter? :)

My (shade tree mechanics degree) says two engines in a coaxial
configuration could be interesting. :) If one engine *could* provide
enough power to maintain altitude, couldn't you toss the need for
autorotation? I'm ASSUMING the reliability of the rotary built for
proper aircraft use.

I know something along this line has been tried by the Nolan brothers
(two small two strokes)...I have a different twist in my head. I need
massive help!

Thanks guys
Phil

The problem with seperate engines on a coaxial helicopter is that the torque
differential would show up on the tail (rotor etc), and a single engine
failure
would spin you like a top.  A more direct coupling would be in order
for that application, and I do not know if you could sustain on half
power.  maybe crash more softly? Vance

If two engines drive the same input shaft to the transmission, and are coupled through a
mechanical diode, or sprag/overunning clutch, the loss of one engine will just reduce the power,
but not have an effect on the fuselage since the torque is being counteracted by the two rotors
running in opposite directions.
One rotor inputs counter clockwise torque to the fuselage, and the other inputs clockwise torque,
thereby cancelling out the torque.
The same as a tandem rotor.
Here is a link to a page that gives some details on a good coaxial.

Gyrodyne

Royce

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.