Subject: [Fwd: Oil Injection Pump Drive Block]
From: ACRE
Date: 4/17/2003, 6:59 PM

Fred Osborn wrote:

A while back there was a discussion regarding how to block
off the hole left when the oil injection pump drive was
removed. Some felt that the oil supply to the drive hole
should be continued to provide a spray lube for the main oil
pump drive chain. I concede that Tracy and others have
demonstrated that this is not required. At any rate I still
thought I would try to find a simple (cheap) way to block
the empty drive hole and still permit the flow. The attached
JPEG shows my solution.

000 faucet washers fit snugly in the empty drive shaft hole.
I went upscale with Teflon washers from McMaster-Carr. A 1"
long, 5/16" standoff - 10/32 thread (McMaster-Carr), with 2
ea. 1" cap screws, 2 ea. #8 washers, and 2 ea. 3/4" fender
washers complete the assembly. The fender washers have to be
drilled to take the 10/32 screws and one washer OD
has to be reduced to fit inside the outer hole. The hardest
part was finding a 5/16 socket slim enough to fit in the hole

Probably overkill but the mental exercise was enjoyable.

Fred O.

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.