Subject: Aluminum end housings
From: ACRE
Date: 4/17/2003, 12:36 AM

Over the years I spoke to Alturdyne Paul Ross at several Airshows. 
Alturdyne claims to have made many aluminum end housings used in 
single Mazda rotor gen. sets. Paul claims the only coating that 
works is detonation gun applied. The same process Mazda choose 
for the four rotor Lemans winning engines.
Like the exploding tungsten wire Bill Jepson described
tungsten carbide particles are fired out of the barrel of a gun
at supersonic velocities and embed themselves into the 
wear surface forming a strong mechanical bond. This is opposed
to a thin molecular bond such as would be obtained by anodizing
or chrome plating.

The problem with this is it is very expensive and the surface
must be finish ground with a diamond wheel. If damaged I don't 
think it can be repaired. The entire end housing probably
must be scrapped.

An embedded through hardened steel insert on the other hand
can be reground at low cost by an ordinary grinding wheel.
 
Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.

DETONATION_GUN_SETUP.GIF