ddunbar wrote:

Hello Paul,
I have just finished my radiator of which the core was made in South
Australia by a company called ADRAD PTY LTD. This is a two row core
with 27 water passages in each, the tube size is 25 [1"] x 1mm.
Core size is 460 [18"] x 325 [13"] plus the end tanks.
The core cost me $410 Aus or $250 US plus the cost of the end tanks.



--
Best regards,
 ddunbar                          mailto:ddunbar@echidna.id.au

That is a pretty good price. Where and how are you going to mount it?
That is the hard part :)  (That's Don's 98 3rd gen in the background.)

BTW if you use only one runner for the two center intake ports you should

make

it half as long as it pulses twice as often.

Paul Lamar

Hello Don,
Centre port-- Bugger!!
Why didn't you join the centre to the side ports and have two tubes only?
Hey! like the Rad - good price also.
I especially like the tapered end tanks - your design or someone else's. If
it works for air....... !!
George (down under)

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.