Paul Lamar wrote:
How did that dyno run go yesterday Al? We are all waiting with
baited breath.
God Lord I hope not. The word is "bated" as in "abated".
Runs went fine after solving timing issue. Don't want to publish before
data is complete, checked and analyzed; but right now I'm pretty
excited. Torque curve very flat 2500 - 6000 at about 200 - 220 ft--lb,
hp about 255 at 6000; still going up in a straight line; so we are going
to have to run to higher rpm. Coolant flow 48 gpm @ 6000, oil flow 15
gpm @6000.
Al
Thanks Al. Good info on the coolant flow and oil pump flow. Is that through
a rad and an oil cooler? I assume you have flow
meters in the systems. Whose dyno? Perhaps some of us would like to rent
some development work. 85 HP per rotor at 6000 RPM not bad.
(two rotor equivalent 170 HP).
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.