tim tracey wrote:
> >>
> >> I'm finally to the stage where I can start looking
> >> really hard at the actual build-up of my 13B for my
> >> pusher config......I'd appreciate any and all
> >> suggestions(no matter how outrageous)as to producing a
> >> consistently high HP output at 4,000-4,500RPM. The
> >> unit will be geared 2:1 to an inflight adjustable
> >> 3-blade 58" prop with 30-105" of pitch and oodles of
> >> blade area.
> >>
> >> I am now lowering my shields........LOL!
>
> At that rpm it should push you down the taxi way just fine.
>
> Ken Welter
Why the low RPM? Power is far easier to make up at 6,500 RPM. Lighter rotor
bearing loads above 6,000 RPM. I am not a math major but I don't think you
can do it at only 2000 prop RPM. If it gets off the ground, it won't be very
fast. There is a formula for this to be sure, but close to 3,000 prop RPM
should do it. Racers are turning 13Bs up to 9,300 RPM. The engine is not
highly stressed at all at 6,500 RPM. Why the interest in turning 4,500?
Lynn E. Hanover
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.