tim tracey wrote:
> >>
> >> I'm finally to the stage where I can
start looking
> >> really hard at the actual build-up of my
13B for my
> >> pusher config......I'd appreciate any and
all
> >> suggestions(no matter how outrageous)as
to producing a
> >> consistently high HP output at
4,000-4,500RPM. The
> >> unit will be geared 2:1 to an inflight
adjustable
> >> 3-blade 58" prop with 30-105" of pitch
and oodles of
> >> blade area.
> >>
> >> I am now lowering my shields........LOL!
>
> At that rpm it should push you down the
taxi way just fine.
>
> Ken Welter
Why the low RPM? Power is far easier to make up at
6,500 RPM. Lighter rotor
bearing loads above 6,000 RPM. I am not a math
major but I don't think you
can do it at only 2000 prop RPM. If it gets off
the ground, it won't be very
fast. There is a formula for this to be sure, but
close to 3,000 prop RPM
should do it. Racers are turning 13Bs up to 9,300
RPM. The engine is not
highly stressed at all at 6,500 RPM. Why the
interest in turning 4,500?
Lynn E. Hanover
>From my checking, I've found power in a rotary can be
made clear out to 10,000RPM if extreme short-life is
not a problem, but I'm after extended
engine/drivetrain life, and a low gear PSRU. Besides,
I never designed my rig for speed anyhow(it's more of
a show-boat.) My feeling is that if I can make decent
power with a 4,000-5,000RPM setting on the rotary, and
let all components in the drivetrain take some of the
workload, I'll see good TBO's and I'll still have a
substantial RPM band to work with........'course, I
could be wrong.....LOL! Crook convinced me with an
awesome ride in his RV and at the time he was turning
a fixed 2-blader, 2:1 drive and his very ordinary
13B(which first started me drooling about rotaries!)
But I'm still open to any and all suggestions.....& I
will look into those lighter load
bearings......thanks!
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.