--Dan Ruggirello wrote:
Bill,Paul,
Do you have the fastener locations where the beam is attached to the block?
Does the block rest on the beam as shown?
Dan
Long oil pan bolts. The engine rests on the beam.
Paul Lamar
A couple of details. The 3-D sketch that Paul put on of the end of the "Schertz beam" is not correct. The end is all made of 1/2" 2024 Aluminum. The extra space between the Aluminum tongue that goes inside the 4130 .065 wall rectangular tubing is taken up by 4 spacers on each end so that the bolts can be torqued without crushing the rectangular tubing.
The holes for attacing the beam to the block are the oilpan bolts, with a 4130 tubing welded across the interior to keep the tubing from collapsing. Paul has a picture of that somewhere. I am on travel, and can only access the e-mail, not my photos.
Bill Schertz
Me? That was Dan's 3D :) At least I don't remember doing that 3D :)
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.