I did all the home work on 90 degree tubing bends for the intake manifolds.
RB Wagner wants about $25 apiece for the proper OD sizes with
a .140 wall and one five inch leg which is a bit heavy. 

Burns Stainless charges about $30 each and the tubing is not heat 
treated afterwards. Not a good idea IMHO.

I can get it done here in LA and ship it to you for $20 each.
Plus $15 shipping UPS gnd for the lot. There will be two six inch legs.
Four inch center line radius.
The OD will be two inch with roughly  .125 wall on the
large size and 1.75 inch OD with .125 wall on the small size.
This fits the manifold and runners well. Material is 6061 T6

There is a lot of running around involved. Buy the tubing, take
it to  have it annealed, pick it up and take it to
the bender, pick it up and take it back to have it heat treated and
pick it up and ship it.

The initial batch will be about 36 sets of four.  So if you want to
get on the list send me a check for $105. When I get 
close to 36 sets sold I will let people know so they can stop
sending checks until the next batch. First come first served.

Send check to:

Paul Lamar
830 East Santa Maria St.
Suite 303  <<<<<very important.
Santa Paula CA
93060

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.