Subject: 12B rotary questions
From: ACRE
Date: 4/28/2003, 1:51 PM


Hi Paul

I am a co-worker at DALSA of your son Paul and also a rotary enthusiast.

He told me that you could give some insight to the engine of a 1983 RX-7
Targa-7  (12B carburated) I ran across and am thinking of buying. I know it
is hard to get much useful information on an engine from an email, but if
you could give some insight I would be grateful.

1st is that there is a significant hesitation from 750 rpm to 1200 rpm,
almost like the engine is choking. This happens when cold or at operating
temp.
2nd is that the pull from 3000 to 7000 RPM is much less pronounced than my
previous experience (1980 version of RX-7). The rate of change from 3000 to
7000rpm is much slower  than the rise from 750 to 3000. I am guessing it is
the timing not set up properly but I wonder if that could be a sign of bad
Apex seals? (I recall the timing is critical for the second plugs above
3000RPM from the 1980 RX7 I owned 12yrs ago)
3rd is that the engine stalled during my run and took 2 min of turning the
eng over (very light hits on the gas) to have it start again. It only
restarted once the started got the engine spinning significantly fast. I
recall the fickleness to flooding on my 1980 but I do not recall that it
had to spin so long and so fast to restart in my 1980?

Do you know of any experienced rotary mechanics in the southern Ontario
area?

Notes car has been sitting (with current tank of gas) for 18 months it has
190,000 Km (117kmi)

Thanx for any help.

Bill Blyleven


 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.