Mark Steitle wrote:
 >
 > Paul,
 > Sorry to bring this up again, but I could use a little help.  I recently
 > ordered TES o-rings from Creavey and they arrived yesterday.  The inner
and
 > outer oil o-rings fit perfect, but the outer coolant o-ring is too big by
 > about a 1/4".  Here's a quote from a recent message on this topic which

is

 > where I got my measurements.

Cut the ring on a long diagonal with a razor blade. Lay the ring in the
groove. Cut away the excess ring along the plane of the first cut. Press the
ring into the groove.
Add a small blob of 100% GE silicone sealer (I use white tub calk) to the
joint.
Make the joint on the top center of the engine. It works as well as the stock
ring.
No problem.
Lynn E. Hanover

The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.