Subject: Aluminum end housings - CG
From: ACRE
Date: 5/2/2003, 11:11 PM


     > Just came away from a meeting with the aluminum end housing coalition.
     > IE. Foundry.. machine shop.. pattern maker.
     > They have come up with a very VERY good way of positively locking the through
     > hardened steel wear surfaces into the aluminum castings. We are
     > all very excited about the prospect of a 150 pound rotary engine
     > putting out 250 HP and doing it with no fuel burn penalty.
     > Now if I can get 15 pounds out of a 3:1 gear box we
     > will have one heck of an aircraft engine.
     >
     > Paul Lamar

     > I'd be pretty excited about 200 hp out of a 150 lb. engine. If this works, it's going
     to be damn
     > near revolutionary (No pun intended). I might have to wait and rebuild my engine as an
     all
     > aluminum engine.  I've got my fingers crossed.
     > Brian Trubee

     -----------------------------------------

     Brian,
     Your RV-4 motor mount appears to be quite a bit longer than mine; I think (it's been
     awhile) that my engine/redrive CG is 3 inches further forward than an O-320 (and even
     that makes me a little nervous even though the RV-4 is usually a little tail heavy) and
     your motor mount looks to be quite a bit longer than mine.  Anyway, if these end
     housings become available I will be rebuilding motor mounts while you may be OK.  That's
     40 - 45 pounds that I'll have to allow for when calculating the CG.

     Ken Powell

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.