Subject: Failed water pump pulley.
From: ACRE
Date: 5/6/2003, 11:50 PM


A. Well first it is mild steel by definition because it is so deeply
formed.
Mild steel has a very poor fatigue life compared to 4130. The fatigue
stress level for long life on mild steel is 15,000 psi. For heat
treated
4130 steel it is about 65,000 psi. That is strike one.

B. The area of the 90 degree bend is thinner because of the deep
drawing
manufacturing process which is the high stress area. Strike two.

C. Any nicks or flaws in this area would cause the fatigue
crack to start near the nick or flaw.

D. The pulley is in severe cyclical bending
due to belt tension and V groove offset from the end of the shaft
which is aggravated by continuos use at high RPM. A classic
case for fatigue  failure. Strike three. Only four bolts
out of the eight does not help.

I added a picture of my own to show people what it looked like before
the failure.

The only solution I see is for everybody flying to take their water
pump
pulley off and have it magnafluxed right away for cracks. Also make
sure you do not have too much belt tension.

The possible permanent fix would be a 2024 T6 or 6061 T6 thick
aluminum billet
pulley at least 1/4 inch thick everywhere. Even that might be subject
to eventual fatigue because of this less than ideal design
configuration.
Aluminum fatigue characteristics are not all that great.

Perhaps a heat treated  4130 steel billet pulley would be the ultimate
answer.
That would not be cheap to machine. A partial, close fitting, 4130
steel billet cap would also help and would be cheaper than
a complete 4130 steel pulley. A large 4130 washer with eight holes in
it would also help but not as much as a cap.

Moving the V grooves out closer to the end of the shaft would
help this situation but hurt the the shaft outer bearing life.
That would mean changing the pulley on the e-shaft and relocating the
alternator or  relocating the water pump similar to what
Don Dunbar is advocating.


Paul, I think Mazda put 8 bolts on there for a good reason.  Here a
link to a picture of Eagle R&D making pulleys:
http://www.helicycle.com/news/turbinegearbox.htm

I would love any comments or criticisms of this turbine install.

Hans


The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.