Paul Lamar wrote of Ian Beadle's water pump pulley failure:
Moving the V grooves out closer to the end of the shaft would
help this situation but hurt the the shaft outer bearing life.
That would mean changing the pulley on the e-shaft and relocating the
alternator or relocating the water pump similar to what
Don Dunbar is advocating.
Russell Kent wrote:
OK, so I'm going to expose my engine ignorance here (be
gentle). Why is the water pump shaft so long
(which in turn requires that deeply cupped pulley)? Was the
engine-driven cooling fan attached to the
end? Would it make sense to cut down the water pump shaft and
housing, and use a less cupped pulley?
Russell Kent
Originally it had a large fan and silicone filled fluid coupling.
That put a large cantilever load on the water pump shaft which
required wide spread ball bearings. That was what the other four bolts
were for. BTW the mechanical fan has been done away with on the
RX8 and perhaps the third gen but I am not sure.
Paul Lamar
How many hours does Tracy have on his water pump? And does he have 8
bolts vs. 4? How about Ed?
Bill Schertz
Ed is checking his as we speak.
Paul Lamar
Paul,
What difference, if any, would it make by removing the fan clutch flange
from the water pump/pulley interface? Normally it sandwiches the pulley
between the two pieces. Seems this would help to distribute the stresses
caused by the bolt heads. Would it help to put a .125" flange between the
pulley and the bolts, simulating the fan clutch flange?
Also, I can't remember for sure, but I think my 20B pulley has a
reinforcing cap similar to your proposed fix. I'll check when I get home
and send a picture if it does.
Mark S.
Yes. Good idea. That would help.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.