Subject: schertz beam fem analysis
From: ACRE
Date: 5/7/2003, 3:39 PM


Dan Ruggirello wrote:

I appologize about the delay - had to get cracking on the vertical stab.
Here is the FEA of the Schertz beam.  Applied load is based on 6G's and the
beam assumed to pick up 2/3 of the 1800lb load, or 1200 lbs.  This is what
Bill used in his spreadsheet.  The load was distributed over the footprint
of the block.  I did not apply the "gyroscopic kick load" from the prop -
that would be a different load case.  For that case, if the brackets that
Chrissi mentioned are excluded, there is a potential for the oil pan bolt
loads to go up dramatically because of the heel-toe reaction of the block
against the beam.  This depends on the load path - how much load the rear
engine support picks up vs the beam.

I tied the oil pan bolt holes rigidly together in Z to simulate being bolted
to the block - I could have tied them in X and Y as well but the results
will be similar.  I had to estimate the pan bolt spacing.  I assumed the
holes go completely through the beam for access.

For the beam, looks like max gross stress away from the holes is about 40ksi
vonMises.  Near the holes the stress is of course higher but the stresses
here would be spread out a bit because of the area of the fastener heads and
also fastener head friction from beam to block.   So, if you use a factor of
safety of 1.6 yield and 2.0 ultimate it seems OK.  Per Mil-HDBK-5, 4130
normalized.tempered, stress relieved is good for 75ksi yield/95ksi ultimate.
BTW, the model values are vary favorable with the hand calcs Bill did.  His
hand calcs show higher stress because of the applied concentrated center
load - the loads are distributed in the model.

For the aluminum tabs, the stress levels seem acceptabe.  Max stress appears
to be about 16ksi.  MIL-HDBK-5, Ftu=42ksi and Fty=38ksi for 6061-T651 plate.
Positive margin of safety with FS of 1.6 yield/2.0 ultimate if the 6G load
is conservative.

Dan


Dan,
No apologies needed, I appreciate your being willing to do it. I am planning on putting the "kick" tabs in before finishing the motormount, but haven't done it yet.

Thanks again.
 Bill Schertz
KIS Cruiser # 4045

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.