The Lycoming weenies are going to wonder where the severe head wind
came from :)
And this is only 87 HP per rotor at the benchmark RPM of 6000.
This data makes the best case yet for the 2.87:1 redrive. 7500 RPM for
max power is almost perfect
at just over 2600 prop RPM. If the HP curve continues then 300+ Hp
should be available at 7500!
Yipee. It's too bad Mazda isn't making them anymore. It sure begs for
an intermediate housing and
e-shaft in the aftemarket. Bill J
I don't think we ought to mess with the 2.85:1 drive. I think we should
focus on
the 3.15:1 drive as the RX8 motor will come on like gangbusters as
within a year
there will be at least 18,000 of them in the US alone. Ford/Mazda is
also making noises
like a whole bunch of cars will be using the RX8 motor. A new RX7,
Miata,
convertible RX8, etc., etc.. The last shaft I uploaded was scaled to the
3.15:1 gear set.
These ratios and high RPM operation may be great for the renesis engine;
but in chasing that higher power with the existing engines, don't forget
that there are engine endurance and reliability issues that are being
affected.
Al
Ken Welter has had lots of experience with 3.15:1 and 2.95:1
gear ratios. There is no noticeable reduction in engine life.
At least as far as Ken has mentioned. the lighter rotors in the RX8
engine should help greatly.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.