Subject: 20B dyno test - Torque/ HP
From: ACRE
Date: 5/8/2003, 7:34 AM


The Lycoming weenies are going to wonder where the severe head wind came from :)
And this is only 87 HP per rotor at the benchmark RPM of 6000.


This data makes the best case yet for the 2.87:1 redrive. 7500 RPM for max power is almost perfect
at just over 2600 prop RPM. If the HP curve continues then 300+ Hp should be available at 7500!
Yipee. It's too bad Mazda isn't making them anymore. It sure begs for an intermediate housing and
e-shaft in the aftemarket. Bill J

I don't think we ought to mess with the 2.85:1 drive. I think we should focus on
the 3.15:1 drive as the RX8 motor will come on like gangbusters as within a year
there will be at least 18,000 of them in the US alone. Ford/Mazda is also making noises
like a whole bunch of cars will be using the RX8 motor. A new RX7, Miata,
convertible RX8, etc., etc.. The last shaft I uploaded was scaled to the
3.15:1 gear set. 

No mention of a three rotor in the future. Actually what
was mentioned was a larger two rotor with 90 mm (3.5") wide rotor housings.
Max RPM would be about the same but torque would be higher.... particularly
down low where it is needed for the cars. Max HP might be no higher
as breathing areas would be substantially the same unless a peripheral
ports where used.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.