Subject: 20b Dyno Data manifold pressure
From: ACRE
Date: 5/8/2003, 7:03 PM


And speaking of breathing; the engine has a tangential manifold/muffler
with the exit out the rear end (2 3/4"). Just a few inches downstream is
a secondary custom muffler that has an inner perforated tube (1/4"
holes) surrounded by an outer tube.  The inner tube has a slight
restricting orifice in the center to encourage some of the flow to go
through the holes.  The system was connected to the dyno exhaust system
which also contains a large muffler.

Power runs were made with the dyno muffler disconnected, and with both
the secondary muffler and dyno muffler diconnected.  There was
essentially no change in the power output from the baseline case.

Sound level measurements about 8 ft away at about a 45 degree angle from
the exhaust exit were taken with and without the secondary muffler.  The
readings at full power were 126 dB without the secondary muffler, and
120 with it on.  Both are high, but the good news is that the secondary
muffler provides a 6 dB reduction without affecting the power.  NO doubt
about it; it was a powerful sound.  We were not able to measure at a
point 23 meters perpendicular; or whatever the standard is.  At low
power low rpm, like taxiway operation, the sound was quite gentle; I'm
guessing little or no worse than a Lyc.

AL

AL
What were the dimensions of that secondary muffler.
George (down under)

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.