Subject: pictures of manifold
From: ACRE
Date: 5/9/2003, 8:04 PM

William wrote:

Paul, here are a few pictures of the completed manifold on the engine. I used RB-Wagner bends,
adding a length of pipe to make the distance.

Some specs:
Weight ~7 pounds as welded
Length of runners ~17 inches, measured by shoving a metal tape in one end and letting it come out
the other.

I had to grind off a spot on the cast iron on both ends of the engine for the fit, it is really
about as low profile as it can be made. There is no extra room between the engine and the manifold
as it goes over the top.

It looks like I will need a cowl bump to accomodate the injectors and manifold tubes. Too close
for comfort.
Bill Schertz
KIS Cruiser # 4045


Nice work Bill. If you rotate the injectors with the electrical connectors
on the bottom they should be no higher than the pipe bends. I planned
it that way.

BTW Ed Kleipis, this is what you will be doing on mine along with the intercooler.
Do you have an intercooler core picked out yet?

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.