Subject: pictures of manifold
From: ACRE
Date: 5/10/2003, 6:17 AM

William wrote:

I had to grind off a spot on the cast iron on both ends of the engine
for the fit, it is really
about as low profile as it can be made. There is no extra room between
the engine and the manifold
as it goes over the top.

It looks like I will need a cowl bump to accomodate the injectors and
manifold tubes. Too close
for comfort.
Bill Schertz
KIS Cruiser # 4045


Nice work Bill. If you rotate the injectors with the electrical connectors
on the bottom they should be no higher than the pipe bends. I planned
it that way.

BTW Ed Kleipis, this is what you will be doing on mine along with the
intercooler.
Do you have an intercooler core picked out yet?

Paul Lamar

----------------------
Paul,
The top cowl interferes with the top of the bends/injector ports as it sits
right now. Manifold cannot be lowered, so I think I am going to need a
raised center section to clear the injectors ports, and turn it into a
dedicated scoop for the air box. Still fiddling with alignments, if the
story changes I will let you know.

Bill Schertz

I knew it was going to be close on mine. The cowl sits on the motor plate.
Rich supplied several different cowls. Do you have the short one or the
long one? I am hoping I can cut off that ugly hump on the bottom :)

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.