Subject: pictures of manifold
From: ACRE
Date: 5/10/2003, 5:04 PM


Paul,
The top cowl interferes with the top of the bends/injector ports as it
sits
right now. Manifold cannot be lowered, so I think I am going to need a
raised center section to clear the injectors ports, and turn it into a
dedicated scoop for the air box. Still fiddling with alignments, if the
story changes I will let you know.

Bill Schertz


I knew it was going to be close on mine. The cowl sits on the motor plate.
Rich supplied several different cowls. Do you have the short one or the
long one? I am hoping I can cut off that ugly hump on the bottom :)

Paul Lamar

Paul,
I have the original short version. It is the front injector that touches the
cowl currently.
Bill

Mine may touch too but it is close. Did you saw off the small
rectangular aluminum plateaus on the very top of the rotor housings?

Does your cowl look like this picture?

A little speed bump over the injector won't hurt either :)

Oh well I did the best I could.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.