Paul,
I have the original short version. It is the front injector that touches
the
cowl currently.
Bill
Mine may touch too but it is close. Did you saw off the small
rectangular aluminum plateaus on the very top of the rotor housings?
Does your cowl look like this picture?
A little speed bump over the injector won't hurt either :)
Oh well I did the best I could.
Paul Lamar
Actually the Aluminum plateaus don't interfere, because the spacing of the
manifold was such that the two tubes are a little forward. I had to grind
some on the cast iron, as shown inone of the pics I sent. To get it any
lower, one would have to
1. cut more flange off of the injector holders, so that each rotor's pair
was closer together, and
2. angle the curved bends to traverse more closely over the rotor, and
3. increase the length of the manifold a little to clear more of the
engine's RHS.
My cowl looks like yours.
Don't get me wrong, the parts are good, it is just that the clearance that
we have to work with is *tight*. I am designing a cowl bump to clear the
manifold.
Bill Schertz
I think the Kis Cruiser and the Lancair 320/360 are the hardest two
airplanes to stuff a rotary under the cowl. Ironically there
is almost enough room on either side for another engine :)
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.