I am all eyes & ears Dan on how to work out the design issues. One idea
is to feed the fluid into an accumulator(s) to be used as the spring force(s).
Dan, every variable length system I have seen uses mechanical actuation other than vacuum. The
reason is as Paul mentioned we are tuning rpm rather than vacuum. There are some situations that
are particularly difficult to tune for. An easy example shows why they invented fuel injection,
and accelerator pumps/"powervalves" for carbs. When the engine is running steady-state at moderate
throttle, vacuum is high. If we then snap the throttle wide open with a load, known as lugging the
engine to most people, the vacuum DROPS TO ALMOST NOTHING. Air flow due to mass is still there,
but vacuum isn't. A large engine without acelerator pumps that is carburetted will stumble so
badly that it will often stop. The problem is that there is no vacuum to draw the fuel from the
float bowl, so some mechanical means is needed. Fuel injection handles the problem with pumps to
deliver the fuel. Sorry to go so long, the short story is without complex methods of accumulating
vacuum, like large chambers with valves etc...you just can't get it to work when you want it to.
Bill Jepson
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.