Subject: water Pump pulley runout.
From: ACRE
Date: 5/18/2003, 6:51 AM


Ian Beadle wrote:

Hi Paul

I installed a new water pump pulley today and checked the runout with a dial gauge. It was way
out! Futher investigation showed that the pulley locating spigot on the shaft is 17mm and the hole
in the pulley 19mm. Also the bolt holes are 7mm and the bolts 6mm.
My cure, as yet untried, is to decrease the size of the locating hole to 17mm by inserting a 2mm
long copper ring 19mm OD 17mm ID. Luckily copper tube comes in the exact size. You have got to be
lucky sometimes.
The picture shows the alluminium disc that holds the vacuum pump drive pulley.
Ian 8 bolt Beadle.

Something wrong with that pulley you have Ian. Perhaps it is from another
year. The three pulleys I have all fit perfectly both bolts and pilot.
Here is a close up of one of my pulleys.

The shaft and pilot hole in my pulley are indeed both 17 mm. The bolt holes in my
pulley are 7 mm.

Paul Lamar

Checking back the pilot hole in the pulley that failed also looks too big.
Where are you getting those pulleys?

-- Paul Lamar The AirCraft Rotary Engine NewsLetter. Powered by Linux. ACRE NL web site. http://home.earthlink.net/~rotaryeng/ Copyright 1998-2003 All world wide rights reserved.