Ian Beadle wrote:
Hi Paul
I installed a new water pump pulley today and checked the runout with a
dial gauge. It was way
out! Futher investigation showed that the pulley locating spigot on the
shaft is 17mm and the hole
in the pulley 19mm. Also the bolt holes are 7mm and the bolts 6mm.
My cure, as yet untried, is to decrease the size of the locating hole to
17mm by inserting a 2mm
long copper ring 19mm OD 17mm ID. Luckily copper tube comes in the exact
size. You have got to be
lucky sometimes.
The picture shows the alluminium disc that holds the vacuum pump drive
pulley.
Ian 8 bolt Beadle.
Something wrong with that pulley you have Ian. Perhaps it is from another
year. The three pulleys I have all fit perfectly both bolts and pilot.
Here is a close up of one of my pulleys.
The shaft and pilot hole in my pulley are indeed both 17 mm. The bolt
holes in my
pulley are 7 mm.
Paul Lamar
Paul I measured the old pulley and it was correct at 17mm. Have to change
the 19 mm one. Fun isn't it!
Ian.
Copper is kind of soft. Don Dunbar has access to a lathe perhaps he can
get a steel collar made for you. He could make several for all you
guys out there in Perth. Could kill two birds with one stone
as it could reinforce the pulley also. Like this one that Ken made.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.