snipss.
Paul,
I'm hoping the 3rd gen 13b turbo impeller is the same as the 20b. Can
anyone confirm/deny this?
Mark S.
No the third gen impeller is entirely different and so is the housing.
The pump might fit however.
Paul Lamar
Paul,
Here's a couple of pictures of the smaller 13B pump next to a 20B
pump. Its hard to tell, but the 20B impeller is .150" larger than the 13B
impeller. Sure wish I knew the gpm for the 20B pump. I'm reluctant to use
the smaller 13B pump on my 3-rotor.
Mark S.
That won't fit the casting for sure. You will have to use the 7 bolt
cartridge from the early 13B pumps. You could always change the
pulley ratio and run it at a slightly higher speed to pump more
water. Also the stock 20B pump is designed with the thermostat in mind so just
taking the thermostat out will pump a lot more water according to
the chart Al Geitzen uploaded.
I'll know more when I get some more data from the bench test on the maximum
speed of the new pump housing. BTW the 3 rotors that Bruce Turrentine
are building up out of 13B parts are using the 13B water pump. That includes
the engine Tracy has.
I would use that pump if you have room for it until the seals
or bearings go out and then switch over to the remote mount pump.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.