Subject: New Turrentine built 13b FS- great deal!
From: ACRE
Date: 5/22/2003, 9:23 AM

Al Gietzen wrote:


New (never run, always stored inside in a high desert
climate) 13b built by Bruce Turrentine to the same
specs as Tracy Crook's current RV-4 engine.  Very very
reliable 190-200 hp.


Where is this HP number coming from?  At what rpm?   Stock ports?

Al

I that number is based on what Tracy is getting Al. He must be getting
close to that or he would not be going 214 MPH. Those are third
gen end housings as I recall with a mild street port and a dynamic
chamber tuned for 3000 and 6000 RPM. Probably not much larger
than the stock three rotor intake ports. You do have a stock
three rotor do you not? 

Tracy's manifold  is made from a modified six port
lower manifold further modified with JB weld to plug up the unneeded
six port channels and parts of other stock manifolds, tubing and
a home made dynamic chamber. I cannot find a good picture
of Tracy's manifold right at the moment but here are some pictures of what
is reputed to be an exact copy. The dual throttle body is a cut
down stock Mazda as I recall. There is no air cleaner so
that is worth one or two inches of manifold pressure.
His compression ratio is slightly higher than yours but that should
not be that big a deal.

I would let Tracy be more precise but judging from the email bounces I get
it appears he only receives half his email and he might not get
this. Bruce could also chime in here if he so deemed.

IMHO your biggest problem is your manifold is not tuned.

Paul Lamar

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.