RotaryResources@aol.com wrote:
What about the torque on the 20B bolts Bruce ? :)
~28 ft-lbs for the 10mm
~35 ft-lbs for the 12mm (too much and the sealing washers will
crack)
Front hub nut. 300 ft-lbs to seat the front lobe, then 125 to 150
depending on thrust bearing
endplay with blue lock-tite
Bruce
Bruce,
Thanks for the torqe spec info, especially the front hub procedure.
Mark S.
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.