Subject: Another oil injection failure mode.
From: ACRE
Date: 5/23/2003, 2:20 PM


These are 3rd gen air assisted apex seal oil injectors.
Apparently there is some sort of diaphragm in these
things that failed resulting in the loss of apex seal
oil to the rotor housing. Result... two scrap rotor
housings with chatter marks. Don't take any chances.
Mix two cycle oil with the fuel and forget the
$1,100 oil metering pump and its fragile plumbing..

Paul Lamar


So why can't we do both?
We have the metering pump by-pass kit to get oil from a resevoir.
We put an earlier gen front cover on to allow us to use the mech pump.
Are the 2nd gen oil injectors different in such a way as to not have this failure mode?
Will the 2nd gen oil injectors work in our 3rd gen rotor housings?
...Chrissi

At your own peril Chrissi. I think a lot of engines are in junk
yards because of one kind or another of apex lube system problems.
Those puny five cent nylon lines get brittle and get cracked.

Paul Lamar

Paul, whats the peril, I said BOTH?
What I was trying to get was something usable informationwise not just get dismissed, thanks.
...Chrissi


OK! You are NOT dismissed. Come to attention soldier!

Hey no skin off my teeth if you want to do both. Are you worried about
forgetting to put oil in the fuel? George Graham did that and flew half way
across the country. Did not seem to hurt the engine as apparently he is still
flying it as far as I know.

Paul Lamar

The point really was that if good lubrication is the secret to longevity, then whats wrong with a
belt and suspenders approach to getting it there?
Also my second question was if the 3rd gen diaphram types are no good then are the 2nd gen any
better and will they fit?
...Chrissi

I think they will fit but second gen are also air assisted as I recall.
I just checked. Yes they are air assisted. 

This has not been mentioned before when this subject
has come up in the past. THEY WILL NOT WORK unless the
air pump is installed. I don't know anybody that is running the
air pump. Perhaps as a vacuum source for gyro instruments.
As I recall Ed Anderson is running it as a vacuum source 
but I don't think he has plumbed it to the oil injectors.

Ed? 

Also the second gen used four lines instead of only two like the third gen.
Two of the four injected oil into the intake manifold.

The first gen 12A engine was not air assisted, used two lines
and injected oil into the float bowl.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.