Subject: Another oil injection failure mode.
From: ACRE
Date: 5/24/2003, 6:51 AM


These are 3rd gen air assisted apex seal oil injectors.
Apparently there is some sort of diaphragm in these
things that failed resulting in the loss of apex seal
oil to the rotor housing. Result... two scrap rotor
housings with chatter marks. Don't take any chances.
Mix two cycle oil with the fuel and forget the
$1,100 oil metering pump and its fragile plumbing..

Paul Lamar

Lots of snips..

When I built my new intake manifold I removed the two oil injectors from
the manifold but retained the two in the engine. I also mix two-stroke
oil with the fuel. The air lines that go the injectors do not come from
the vacuum pump, they route to manifold vacuum. I'm guessing they reduce
oil flow when the manifold pressure is low.

--
Perry Mick
Custom Composite Props
mick@bridgingworlds.com
http://www.ductedfan.com

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.