We can make oil injection lines of any length using polyimide tubing. I'm not sure off hand of the
temperature rating, I'll try to look it up. The tubing is semi-flexible, it can't make very tight
turns, but it is not as hard as the stock nylon. If you use longer lines, you can route them away
from hot parts on the engine.

Jon Lauter
Rotary Power Marine Corporation
516-656-5685

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.