Jim Brewer wrote:
 > >
 > > Was said: The first gen 12A engine was not air assisted, used two
 > > lines and injected oil into the float bowl.
 > >
 > > How was this accomplished?  Could it be adapted to 2nd and 3rd gen
 > > engines to mix 2 cycle oil into the fuel?
 > >
 > > Jim Brewer

Why not?

The 12A just dropped it into the float bowl. Try plumbing the two oil lines
into a pair of pin holes ahead of the butterfly in the throttle body. in most
cases there my be vacuum bleeds right at edge of the butterfly that may be
used. I think it would work fine as long as the lines are not exposed to a hard
vacuum when the butterfly is closed. A very small amount of oil is involved.

Lynn E. Hanover

The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.