Subject: Mustang II turbo installation.
From: ACRE
Date: 5/25/2003, 10:09 AM

kevin lane wrote:

I am curious, when I look at other's installations it appears there is much
more room above the engine block than in my RV-8 w/20B, which is basically
12" above crank centerline at the firewall to 8" at the front of the block.
What is the Mustang II clearances?
    I am having to install my primary injectors on the underside of the
intake runners for instance.  I am finally getting to the throttle body.
Turrentine told me  a 5.0L would work fine (2 3/8" dia) which is a long ways
from a 4" (2.7 times the cap) which I heard recommended on this list.  I did
notice that the throttle axle piece that holds the two 2" brass plates from
the stock carb could also hold a single 4" plate easily, so fabricating a 4"
might not be too difficult.  I might even attempt to saw off the bearings
and weld them to a piece of 4" pipe if I decide I need the humongous
throttle.
    It's exciting to see your progress.  I hope to later turbo my engine and
will be much interested in learning from your installation.
Kevin Lane  Portland, OR
e-mail-> n3773@attbi.com
web-> http://home.attbi.com/~n3773

Keven a 2-3/8 throttle body is too small. There will be a loss of manifold
pressure. It is nearly impossible to make one too big.

Are you using a step down in the intake manifold for the injectors
such as in this picture? This almost fits under the cowl of a Bill Schertz's
Kis Cruiser so it should fit an RV8 no problem.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.