Subject: Calculating the speed of sound in intake pipes.
From: ACRE
Date: 5/27/2003, 6:27 AM


You need to know what it is to calculate the tuned length of your intake
pipes.

The speed of sound mentioned in Scientific Design of Intake and Exhaust
Systems the exhaust  part of the book was somewhere between 1300 and 1700
FPS
obviously that was for hot exhaust gas. Intake pipe speed of
sound will be slower.

The best thing is to determine the pipe length by experiment
and that is exactly what Mazda did with the Lemans engine.
That automatically accounts for the actual speed of sound
in the pipe.


Agreed, the speed of sound clearly is a combination of several factors in
the intake, air density, temperature being two of the more dominate ones.
Probably impossible to calculate and they undoubtedly change as conditions
change, so experimentation would definitedly be the best approach.


The Lemans Mazda SAE paper is the best as it shows the torque
curve for each pipe length. Here is the chart along with a drawing.
The numbers shown are in addition to the static section
so 175 mm gives an overall length of about double that and then
some. My guess is 380 mm or about 14 inches for 6000 RPM.


Aha! I missed that point about the dimension shown being in addition to the
fixed static section.  Now the dimension makes  more sense to me.  The power
curve show a big increase at around 6000+ rpm!.


The torque curve shown for the fixed pipe length at 6000 RPM
is rather peaked so the BSFC would not be too good at 4500
to 5500 RPM cruise. Might be better to make it variable
so it can be lengthened for cruise and better BSFC.


Gee, I think the next time I fly I will shorten my plenum by the variable 3"
and see if I can detect any difference.  Been meaning to do that, but other
variables aways got in the way.  Engine has been performing nominally for
about 50 hours steady, so will provide a bit more stable baseline to measure
against that previoulsy.


Now the question is; would a fixed dynamic chamber of total
pipe length of 14 inches port to port give a broader
torque curve? I suspect it would but perhaps less
peak power.

Good question, we need that guy with all the money and time to conduct some
of these experiments.

Again Paul, thanks for taking the time to explore/explain this aspect.  I
did get your diagram about the two systems and have a couple of comments
that I will address in my response to it.  But, suffice it to say, I
understand the two concepts, although I do have a question about why the
pulses in the two concepts seem to be affected differently by the "T".  But,
wait until you get my response to that as I may have figured it out by then.
Good drawing explaining the two concepts.

Ed

Actually I consider them two different modes of operation of
the same concept. Important distinction.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.